UT3G "Monolith" eGPU Dock Chassis | Premium Open-Frame Enclosure

Please Note: Currently shipping in about 2-weeks from ordering due to high demand!

Crafting Solutions, One Layer at a Time – Made in Wylie, TX by Zephyr’s Market

Based entirely on the premium "Monolith" design specification, the Monolith is a complete rethink of the standard external GPU enclosure. Rather than treating the bare board as a problem to hide, the Monolith acts as a low, wide, dense-looking architectural plinth for your graphics card to stand on. By keeping the GPU and power supply in free air, this dock delivers flawless thermals and allows a single SKU to fit nearly any graphics card footprint.

Why Choose the Monolith?

• Zero GPU Sag & PC-Grade Support: The heavy-duty structural spine holds your card exactly like a PC case's rear rail. The GPU bracket tab presses against the mounting face and locks in securely with a horizontal knurled M3 thumbscrew.
• Unrestricted Thermals: The ASM2464PD controller heatsink passes completely through an accent-framed window in the deck. Five precise intake slots in the floor feed the heatsink from below, while your GPU's own fans blow cooling air directly onto it from above.
• No Clicks, No Rattles: The flush deck is held seamlessly by eight pairs of concealed magnets and lifts easily using a built-in finger scallop. The GPU rests securely on a 1.2 mm protruding TPU grip strip within a sculpted fin cradle, meaning your card is held by vibration-dampening rubber instead of hard plastic.
• Smart Cable Routing & Strain Relief: The thick right-angle 24-pin ATX plug seats straight into a dedicated 62 mm power bay, allowing the stiff harness to exit cleanly out the back without bending. The USB-C port is protected by a chamfered 22 × 10 mm bezel designed specifically to accommodate thick Thunderbolt 4/5 overmolds. Your USB4 cable runs securely along an internal channel and exits through a flexible TPU grommet.
• Instant Visual Feedback: Five internal board LEDs are routed flush to the top surface through a custom clear light pipe, allowing you to monitor the safe-shutdown sequence without ever touching the deck. Individual finger windows provide clean access to the switches and jumpers, complete with inlaid accent legends.

Multi-Material Industrial Construction

• The Plinth & Deck: 3D printed in matte ASA (or PETG) to provide high heat resistance (HDT ~95 °C) and prevent plastic creep next to a hot GPU backplate.
• The Structural Spine: Printed flat on its back using ultra-rigid Carbon-Fiber PETG (PETG-CF) or PA-CF to ensure continuous layer strength along the load paths.
• Premium Stance: Anchored by four 20 mm TPU 95A rubber feet planted on an 11 mm wide stance shelf to guarantee an incredibly stable, low-mass footprint.